Viewing 1 post (of 1 total)
-
Posts
-
I’d like to use the basic reflow oven controller shield to instead run a small glass fusing kiln. Glass fusing has rmap and soak profiles not unlike solder reflowing, just at higher power and temperatures — say, 13-15 amps and 1600 – 1700 degrees F. If I swapped in a higher valued thermocouple and SSR, is there any reason why it wouldn’t work for that?
maab
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
