Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 29, 2020 at 6:32 PM #14830
    Roberts
    Participant

    Hi,

    I wonder where can I solder a 1×6 2.54 mm male header onto the controller board for serial communication/power with FTD adapter? You recommend doing this in the setup guide, but I cannot see where I could possibly solder these contacts. Could you please give some hints?

    Regards,
    Roberts

    January 30, 2020 at 8:57 PM #14851
    Roberts
    Participant

    Ok, never mind, I mixed it up with old version of controller board.
    /Roberts

    February 4, 2020 at 12:14 AM #14896
    LIM PHANG MOH
    Keymaster

    Hi Roberts,
    Sorry for the confusion.

    August 29, 2020 at 2:07 AM #15659
    CarlyAzuma
    Participant

    Hello… I would recommend first uninstall the Host Interface Tool. When you reinstall the tool ensure that you ‘Uninstall all previous versions of FTDI’ and install the FTDI drive that comes with the tool. We recommend using FTDI v2.08. This version comes with the tool and is found to be the most stable version. When you don’t uninstall other versions, your system will use the latest one

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.